Results of public testing of lvl 2/3 armor on Didgori vehicles. I'll skip all smaller calibres as nothing noteworthy happened and go straight to 7,62x51 mm and 12.7x99 mm. You can watch the rest for yourself. (
link )
Very limited information on the setup, no info on munition type. McMillan Tac-50 and M2 Browning were used for 12.7x99 mm, firing single shots at flat surface, from 50 m. Results would have most likely been more dramatic, from greater ranges, and obv if targets were subjected to contineous fire.
However this is interesting, because it is the only footage I know, where Didgori armor is tested.
Hits from 7,62x51mm fired with a M240.
Didgori-1/2 lvl2 base armor. Hits generated slightly noticeable rear bulges.
Thicker Didgori-3 MRAP armor. No noticeable difference to other calibres whatsoever.
Didgori 2 Comms & Medevac, double layer plating. Clearly noticeable bulge on thinner front plate, but no penetration.
Hits from 12.7x99 mm fired with a McMillan Tac-50
Didgori-1/2. Result is pretty obvious.
Didgori-3. Took the hit pretty well. No rear bulge.
Didgori-2 Comms / Medevac. Front plate got at least punctured, but didn't inconvenience the 2nd plate.
Hits from 12.7x99 mm fired with a M2 Browning machine gun.
Didgori-1/2. Part of plate got clipped.
Didgori-3. No penetration.
Didgori-2 Comms/Medevac. Rear plate was used in this instance, since it would have obviously penetrated the front plate. No penetration. Naturaly with front layer, it provides even better protection.
Now, what is interesting is that all Didgoris are not intended to protect against anti-material and hmg fire, but max 7.62×51mm AP rounds, so this is a good sign.
Then again, this was not representative of company level testing and combat environment. I think it also makes a difference, albeit maybe a small one, that the armor on the vehicles, especialy the Didgori-1, is angled.
Still cool to see, at least something.